DK VIGTIGE FORUDSÆTNINGER Unidrain er testet og godkendt til indbygning i vådrum – for lokale og nationale regler samt specifikke godkendelser henvises til: www.unidrain.dk Linjeafløbet i denne vejledning er beregnet til montage mod en væg med eller uden sidevægge. Det kræver, at det samles og installeres korrekt. Kun varer og produkter fra Unidrain må anvendes i selve afløbsinstallationen. Tjek om det valgte udløbshus (med hensyn til rør-dimension og flow-kapacitet) lever op til projektet og eventuelle nationale krav inden opstart. Anvendte materi- aler og byggemetoder skal være egnede og godkendte til formålet. Ansvar for tætheden af den samlede afløbsløsning ligger hos de udførende håndværkere. Montage af selve afløbsarmaturet og rørinstallationen, skal udføres af en autoriseret VVS-montør. En del af vejledningen berører andre produkter og materialer såsom beton, primer, vådrumsmembran, lim, fuger og fliser. For information og detaljeret udførelse på disse områder, henvises til leverandørernes anvisninger. EN 1253 *VIGTIGE INSTALLATIONS STEP 1 (illustration 1+2a+2b) Væggen skal være ren, lige og færdigpudset 2 (illustration 3) Anvend glidemiddel på pakning inden montering 3 (illustration 5 + 6a + 6b) Tjek at pakningen sidder korrekt 4 (illustration 10) Tjek at rørsamlingerne er tætte 5 (illustration 14 + 15a + 15b) Støb grundigt under og omkring afløbet 6 (illustration 20) Afrens metaloverfladen grundigt 7 (illustration 22) Sørg for at membranen overlapper afløbsrenden med mindst 40 mm 8 (illustration 28a + 28b + 28c + 28d) Placér rammen korrekt – så vandlåsen kan tages op UK IMPORTANT REQUIREMENTS Unidrain’s linear drain have been tested and approved for installation in wet rooms – for local and national regulations as well as specific approvals, please see www.unidrain.com The linear drain in this guide is designed to be mounted against a wall with or without side walls. It must be assembled and installed correctly. Only Unidrain products should be used in the drain installation itself. Before starting, check whether the selected outlet unit suits the project (in terms of pipe dimension and flow capacity) and meets any relevant national requirements. The building met- hods and materials you use must be suitable and approved for the purpose. The responsibility for ensuring that the drainage solution is watertight lies with the craftsmen who install it. The actual drain unit and pipework must be installed by a qualified plumber. This guide also provides information on other products and materials, such as concrete, primer, wet room membrane, glue, sealant and tiles. For detailed instructions in these areas, please see the suppliers’ instructions. EN 1253 *IMPORTANT INSTALLATION STEPS 1 (illustration 1+2a+2b) Before installing, ensure that the walls are clean and straight 2 (illustration 3) Apply lubricant on rubber gasket before assembling 3 (illustration 5 + 6a + 6b) Check that the rubber gasket is placed correctly and not twisted 4 (illustration 10) Check pipes are connected correctly and watertight V01 4/16 14/5179 5 (illustration 14 + 15a + 15b) When pouring concrete, ensure there are no voids. 6 (illustration 20) Clean metal surfaces thoroughly before applying the membrane 7 (illustration 22) Minimum 40mm membrane applied on the drain 8 (illustration 28a + 28b + 28c + 28d) Position frame onto drain correctly – Check water trap can be removed
Download PDF file