The soap shelf should be fixed with the adhesive supplied, in accordance with these installation instructions. The installation instructions apply to both corner and linear soap shelves. The surface of both the soap shelf and the wall tile must be thoroughly cleaned. S O A P S H E L F, L I N E A R A N D C O R N E R INSTALLATION INSTRUCTIONS > MEASURE AND MARK UP 1 Use a spirit level to mark where the soap shelf is to be placed on the wall. Suitable height 1350 mm. > PROTECT THE WALL 2 Protect the wall from excess adhesive with masking tape or similar. The tape should be applied above the marks. > BRUSH 3 Brush the two glued surfaces of the soap shelf with the supplied grinding pad. > CLEAN THE WALL 4 Wipe clean the wall where the soap shelf is to be glued with the supplied cleaning cloth. > CLEAN THE SOAP SHELF 5 Use the cleaning cloth to wipe clean the two brushed surfaces on the soap shelf that were previously brushed. > APPLY ADHESIVE 6 Open the tube of adhesive and squeeze an even line onto both surfaces. > FIT THE SOAP SHELF 7 Position and push the soap shelf into place using the marks on the wall. Press the soap shelf against the wall for about 15-20 se- conds. Allow to dry for 24 hours. > TRIM THE SOAP SHELF 8 Use a knife to clean the soap shelf of any visible glue that was pushed out when it was fitted. Support your hand against the soap shelf for a clean cut. Then remove the masking tape and install the grating.
Share
Download PDF file
