H H y y d d r r a au u l l i i c c h h o o s s e e S S u u p p e e rf r le fl x ex 6 6 S S T T Hose dim. 1.1/4" Item no. hose 56420-20 Insert type H-Series Ferrule Marking H-20 Crimping dia. 56,1 Insertion Depth 59,0 1.1/2" 56420-24 H-Series H-24 63,2 61,5 2" 56420-32 H-Series H-32 78,0 84,5 2" 56420-32 HLZ-Series HLZ-32 78,2 92,7 Crimping chart Insertion Depth: The insertion dept are stated in the crimping chart. Mark the hose with a white line at stated depth. Push the insert all the way, so the edge of the ferrule gets parallel with the marking. Crimping control steps: Inspect the crimping dimension in the die-set area as indicated in the picture. Take four measurements across the crimped ferrule at 45° to each other using a vernier calipers in the middle section of the crimped length of the ferrule. Verify that all four measurements are according to the designated crimping diameter. Tolerance 0/-0,2 mm. Inspect the crimp taper values Measure the diameter at the top of the ferrule and at the bottom of the ferrule (see picture). Verify that the ferrule taper satisfies the following limits: Taper ≤ 0,6 mm. for hose size from 3/4 inch up to and including 3 inch. Contact your nearest TESS Service centre if you have questions. Reservations for typing error and changes. Marketing/bvs/29.04.2025
Last ned PDF-fil