Before You Drive To replace the battery, following procedures must be observed: 1 Press the release button on the remote key with PEPS; 2 Pull the mechanical key portion out of the key body; 3 Pry up the upper and lower panels of the body, and pour out the printed circuit board with the battery from the lower panel; Caution Never use a metal tool to pry the PCB. 4 Remove the used battery and install a new one; Note: It is recommended to use a CR2032 battery. Caution Pay attention to the positive and negative of battery. 5 Place the plastic bracket with the battery in the lower panel of key body, and then install the printed circuit board; 6 Refit the upper and lower panels of the key body; Caution Do not ignore the waterproof shim onto the upper panel. 7 Press the mechanical key portion into the key body. ! " Caution It is complicated to replace the battery in the remote key with PEPS. In order to prevent the key from being damaged due to misassembly or misoperation, you are recommended to have the battery replaced by Our Service Dealer. 14
Download PDF file