7. Hand torque the screws in the hybrid bases. If there is any uncertainty Verify the seating, with an x-ray. 8. Cover and block the screw head to protect the screw against bonding cement residue entering the screwdriver’s mount. We used thread tape. NOTE: If Hybrid Base surface is contaminated with saliva, clean the surface with KATANA™ Cleaner (see #3) before CLEARFIL™ CERAMIC PRIMER PLUS is applied. 9. Apply CLEARFIL™ CERAMIC PRIMER PLUS for the entire hybrid base surface. Let it air dry. 10. CLEARFIL™ CERAMIC PRIMER PLUS and Pa - navia V5 paste from Kuraray Noritake. Panavia V5 paste is available in 5 different co - lors. The opaque paste is self-curing and the other four are double curing. 11. Apply the bonding cement and spread it with a brush and make sure that all surfaces of the hybrid bases are covered. 12. Place the bridge on the hybrid bases cove- red with bonding cement. Self-Cured: Use pressure (15N) on bridge during curing time. Wait 3 minutes before pro - ceeding to the next step (#13). Light cure: Cure the excess bonding cement for 3-5 seconds, remove excess cement from the hybrid bases. Then continue with light curing for 20 seconds per surface. 13. Remove the thread tape with a sharp in - strument (explorer). 14. Unscrew the bridge, the Hybrid Bases are now fully cured in the bridge. The bridge with its Hybrid Bases is now one unit and intraoral cementation will facilitate the conditions for a passive fit. 15. Ensure that all excess bonding cement is removed before restoration is permanently installed both from the restoration and the patient. 021.405 rev6-EN 16. Screw the bridge to the final torque accor - ding to the implant manufacturer’s recommen- dations. 17. The bridge is mounted without tension on the dental implants. 18. Find the study at elosdental.com
Download PDF file