Ordering Information | Dimensional drawings Ordering correctly Necessary Order Information Complete and accurate data is absolutely necessary for the processing and production of your order, since an accurate and clear order allows us to immediately begin processing your order without time-consuming enquiries. For this reason, your order must contain the following information: • Range name and front number • Handle number • Drill pattern number • Carcase colour number • Plinth height and colour (if not specified, the standard plinth height of 150 mm will be supplied) • Worktop design / décor • Worktop edge design / edge colour • Worktop sketch with dimensions and indication of tongue and groove joints • Design of the worktop outer corner (for APD): square or round • Upright / top shelf design including the colour number and upright thickness / Upright panel floor seal colour • Shelf colours • Glass design and / or colour • Roll-up front colour • Cornice profile / light pelmet profile including colour for each • Order number and / or abbreviation • Manufacturer information and built-in appliance model identification • Kitchen block number (for kitchen block orders) • Layout sketch with dimension information in 1:20 ratio • Please draw / write any special productions in the centre of the layout sketch Dimensional drawings for upright panels Uprights at end of run for base units, sideboards and tall units are supplied as standard with an upright panel shoe. The upright panel shoe is included in the price of the upright panel and is available in: 014 Stainless steel appearance, 010 Black. If no colour is specified in the order, the version 014 Stainless steel appearance will automatically be supplied. The height of the upright panel is reduced by the interior height dimensions of the profile and thus calculated as follows: carcase height + plinth height - 8 mm interior chamfering of the floor profile = material height 2
Share
Download PDF file